Torso - Body Dressing Holder
Non-Sterile Single Patient Use
Reusable Non-Adhesive Dressing Systems
TAPEless
- Latex Free
- Non-Constrictive
- Washable, Reusable
- Works with Any Wound Dressing
Simply works because it works simply.
TAPEless’s clinically proven Torso Dressing Holder is designed by a plastic and reconstructive surgeon to hold any primary dressing in place on the lower chest, abdomen or back without the need for tape, adhesives, elastic netting, elastic wraps, Montgomery straps or rolls of gauze. It is adjustable, washable, reusable, and very cost effective. Due to the anatomical design, it easily fits an individual’s torso, staying in place without the need to sit the patient up, roll the patient over, or use multiple assistants. This versatile dressing holder secures wound dressings on single/multiple wounds on the torso at the same time and can even provide for tubes, drains or ostomies. Its easy application and removal make it ideal for checking wounds and frequent dressing changes.
Sizes Available: Small - 30" Waist, Medium – 42" Waist, Large – 54" Waist, and Bariatric Torso - Waist greater than 54"
Packaged: 1 per pack
| Small - 30" Waist | $28.00 | |
| Medium - 42" Waist | $28.00 | |
| Large - 54" Waist | $28.00 | |
| Bariatric - Waist greater than 54" | $42.00 |
Step 1
Clean wound as instructed by physician and place wound dressing on wound.
Step
2
Place adhesive side of round Velcoin® on the back of the wound dressing.
Step
3
Place the TAPEless holder over the wound dressing. The Velcoin will attach the wound dressing to the TAPEless holder.
Step
4
Comfortably secure the TAPEless holder flaps sequentially around the body securing all three tabs.
Step
5
CAUTION: May impair the circulation if too tight. To replace wound dressing, repeat steps 1-4. If soiled, hand wash holder in warm soapy water and air dry.
IMPORTANT NOTE:
Material will not fray or unravel should cutting be required to fit patient’s needs. Hook fastener may be attached anywhere on the fabric.